I like how the wiring is the same gauge for Hondata s300 v3 and the stealthy look of the location of the resistor
JBtuned Flex Fuel e85 Ethanol Sensor Plug-N-Play Harness for Hondata s300 and Kpro
JBtuned plug-n-play wire harness for use with Hondata s300 v3 or Kpro v4 and a Continental Flex Fuel Sensors.
This harness has a built in 2.4k Ohm resistor that is required for Flex Fuel Sensors to work with your Hondata S300v3.
No resister is installed on the Kpro v4 version as it is built into the Hondata board.
Requires s300 v3 or Kpro v4 - Will not work on earlier versions
Flashpro Users: In order to get flex fuel working you will need a ethanol content analyzer /converter to get the signal into something the ecu can use. Please see Innovate MTX-D Ethanol Content Analyzer.
Harness is made from
Brand new OEM Connectors, pins, and seals
8 feet of Tefzel Mil-Spec wire that exceeds OEM specifications and is resistant to moisture, grease, oil, gasoline, and most acids and solvents making it very durable for engine compartments.
Connect 'VCC' (Red Wire) to switched +12volts
Connect 'Gnd' (black wire) to Analog input harness ground (black wire on Analog connector)
Connect 'Out' (White Wire) to Analog input harness AN0 (red wire on Analog connector)
For more information on the Analog input connectors on the S300, see the S300 help guide here: http://www.hondata.com/help/smanager/analog_wiring.htm.
For more information on the Analog input connectors on the Kpro, see the Kpro help guide here: http://www.hondata.com/help/kmanager/analog_wiring.htm
We also have an option to add the quick connect fittings if you need them. They are 6AN fittings that slide and click onto the flex fuel sensor